ThermoShell - PLINTHCOAT

A robust, internal and external plinth render

Description

A lime/cement plinth render suitable for areas where high impact resistance is required or where exposure to splash back is to be expected.

Application

Clean down background to remove any dust, dirt or any matter which will impair the bonding of the render, using a high pressure water jet where necessary. Mask all dirt sensitive elements.

No preparation is required for new blockwork, only pre-wet where necessary to prevent rapid hydration.

For application to brickwork / concrete / stonework or existing masonry then apply ThermoShell (TS) - RENDERPRIME first and allow to dry.

Apply TS-PLINTHCOAT to a minimum thickness of 10mm internally and 15mm externally, strike off and level. TS-PLINTHCOAT can be applied up to 20mm in a single coat. For thicknesses of 20-35mm then apply in 2 coats allowing for a layer of TS-REINFORCING MESH to the whole surface, brush line the first layer of render and allow to fully dry.

• Dry and pre-mixed
• Low chromate content 
• Water repellent
• Machine or hand application
• One-coat application
• For indoor / outdoor application 

• Product Datasheet
• CoSHH Datasheet

TS-PLINTHCOAT should be sponged or felt floated and finished with TS-SELF CLEAN paint in 1 or 2 coats.

Allow one days drying time per mm applied.

Do not carry out works if the air or surface temperature is 5º C and falling.

Wash all equipment and tools immediately after use.

All ThermoShell products should be installed by an approved ThermoShell installer.

Safety at work

Mineral renders exhibit an alkaline reaction upon contact with water and therefore may cause skin irritation or eye damage. Avoid contact with skin and eyes. Wear eye / face protection In case of contact with the eyes rinse immediately with clean water and seek medical advice.

Please refer to the TS-PLINTHCOAT Safety Data Sheet for further Information.

Environmental

TS-PLINTHCOAT possesses no contents that are ecological hazards and therefore represents no known threat to the environment.

Handling and storage

TS-PLINTHCOAT is supplied in 25kg bags and should be stored In a dry moisture protected environment. Shelf life of 6 months, subject to cool frost free storage.

Product Data